Washington § 47.36.200 - Signs or flaggers at thoroughfare worksites — Penalty.

Full text of Washington Revised Code of Washington § 47.36.200 — Signs or flaggers at thoroughfare worksites — Penalty., with citation guidance and answers to common questions.

§ 47.36.200. Signs or flaggers at thoroughfare worksites — Penalty.

(1) When construction, repair, or maintenance work is conducted on or adjacent to a public highway, county road, street, bridge, or other thoroughfare commonly traveled and when the work interferes with the normal and established mode of travel on the highway, county road, street, bridge, or thoroughfare, the location shall be properly posted by prominently displayed signs or flaggers or both. Signs used for posting in such an area shall be consistent with the provisions found in the state of Washington "Manual on Uniform Traffic Control Devices for Streets and Highways" obtainable from the department of transportation.
(2) If the construction, repair, or maintenance work includes or uses grooved pavement, abrupt lane edges, steel plates, or gravel or earth surfaces, the construction, repair, or maintenance zone must be posted with signs stating the condition, as required by current law, and in addition, must warn motorcyclists of the potential hazard only if the hazard or condition exists on a paved public highway, county road, street, bridge, or other thoroughfare commonly traveled. For the purposes of this subsection, the department shall adopt by rule a uniform sign or signs for this purpose, including at least the following language, "MOTORCYCLES USE EXTREME CAUTION."
(3) Any contractor, firm, corporation, political subdivision, or other agency performing such work shall comply with this section.
(4) Each driver of a motor vehicle used in connection with such construction, repair, or maintenance work shall obey traffic signs posted for, and flaggers stationed at such location in the same manner and under the same restrictions as is required for the driver of any other vehicle.
(5) A violation of or a failure to comply with this section is a misdemeanor. Each day upon which there is a violation, or there is a failure to comply, constitutes a separate violation.
[ 2010 c 8 s 10014; 2006 c 331 s 1. Prior: 2003 c 355 s 1; 2003 c 53 s 258; 1984 c 7 s 202; 1961 c 13 s 47.36.200; prior: 1957 c 95 s 1.]

Notes

Effective date—2003 c 355: "This act takes effect January 1, 2004." [ 2003 c 355 s 3.]
Intent—Effective date—2003 c 53: See notes following RCW 2.48.180.

Source: official Washington text · Last verified 2026-08-27

Frequently Asked Questions About Washington § 47.36.200

What does Revised Code of Washington § 47.36.200 cover?

Section 47.36.200 ("Signs or flaggers at thoroughfare worksites — Penalty.") is part of the Revised Code of Washington, the codified statutory law of Washington. It sets out the legal rule or procedure described in the text above. Statutes are amended regularly, so always verify against the official source.

How do I cite Washington § 47.36.200?

A common citation format is "Revised Code of Washington § 47.36.200" (Washington). Legal writing may require the code abbreviation, section number, and year or edition. Match the style required by your court, professor, or publisher.

Is this the official text of Washington law?

No. This page is for research and education and may not include the most recent amendments. For official current law, check the Washington official source linked on this page or consult a licensed Washington attorney.

How does Washington § 47.36.200 apply to my situation?

Statutes are interpreted in context, and application depends on your specific facts. Only a licensed attorney in Washington can advise on how this section applies to you. Contact your state or local bar association for a referral.

Sources & Verification

Not legal advice. Verify against the official source and consult a licensed attorney in Washington.