Tennessee § 62-2-306 - Effect of certificate — Seal.

§ 62-2-306. Effect of certificate — Seal.

The issuance of a certificate of registration by this board shall be evidence that the person named in the certificate is entitled to all the rights and privileges of an architect, engineer or landscape architect while the certificate remains unrevoked or unexpired. Each registered architect, registered engineer and registered landscape architect shall obtain and keep a seal of the design authorized by the board bearing the registrant's name, the registrant's registration number, the words “Registered Architect,” “Registered Engineer” or “Registered Landscape Architect” and the words “State of Tennessee” or “Tennessee.” The registrant shall stamp with the registrant's seal all original sheets of any bound set of plans and the first sheet of any specifications or reports prepared by the registrant or under the registrant's responsible charge. No architect, engineer or landscape architect shall affix the architect's, engineer's or landscape architect's seal or stamp to any document that has not been prepared by the architect, engineer or landscape architect or under the architect's, engineer's or landscape architect's responsibility. Plans, specifications and reports issued by the registrants shall be stamped with the seal during the life of a registrant's certificate, but it is unlawful for anyone to stamp or seal any document with the seal after the certificate of the registrant named on the seal has expired or has been revoked. As used in this section, “registered architects,” “registered engineers” or “registered landscape architects” means only those registered architects, registered engineers or registered landscape architects who are required by this chapter to be registered in this state. The board may also adopt rules and regulations for the affixing to and endorsement of the registrant's seal on architectural, engineering and landscape architectural documents that may be necessary to implement compliance with this section. Notwithstanding subsection (b), an architect or engineer, after fully reviewing and modifying, as required, may affix that architect's or engineer's seal or stamp to a document, or part of a document, that has been prepared by another architect or engineer, if the document has been designated as a state standard prototype, pursuant to § 12-4-116 [see now § 12-4-111]. The architect or engineer who is involved in a state standard prototypical re-use project, as provided in § 12-4-116 [see now § 12-4-111], shall fully review and modify, as required, the documents and then affix that architect's or engineer's seal or stamp and signature on the documents. The architect or engineer shall become solely responsible for all documents on which that architect's or engineer's seal or stamp is placed. Acts 1979, ch. 263, § 26; 1981, ch. 349, § 1; T.C.A., § 62-226; Acts 1988, ch. 800, § 1; 1988, ch. 990, § 18; 1989, ch. 307, § 4; 1995, ch. 113, § 3. Compiler's Notes. Former § 12-4-116 , referred to in (e), was transferred to § 12-4-111 by Acts 2013, ch. 403, § 79, effective July 1, 2013.