New Jersey § 39:3-61

§ 39:3-61.

(a) Every motor vehicle other than a motorcycle and other than a motor-drawn vehicle

shall be equipped on the front with at least two headlamps, an equal number at each side, and with two turn signals, one on each side; and on the rear with two tail lamps, two or more stop lamps, as prescribed by section 2 of P.L.2013, c. 230 ( C.39:3-66.3 ), two turn signals , and two reflectors, one of each at each side; except that a passenger vehicle manufactured

before July 2, 1954, and registered in this State may be equipped with one stop lamp,

one reflector , and one tail lamp and is not required to be equipped with turn signals. In addition, every motor vehicle shall be equipped with adequate license plate illumination, and with one

or more lamps capable of providing parking light as required in R.S.39:3-62 . Turn signals are not required on the rear of a truck tractor equipped with double-faced

turn signals on or near the front and so constructed and located as to be visible

to passing drivers. (b) Every truck tractor manufactured after January 1, 1965, shall be equipped on the

front with two clearance lamps, one at each side, and three identification lamps, which shall be in addition to the lamps provided for in paragraph

(a) of this section. Where the cab is not more than 42 inches wide at the front roof line, a single lamp

at the center of the cab shall be deemed to comply with the requirement for front

identification lamps. Reflectors required on the rear of a truck tractor may be located on the rear of

the cab, one at each side. (c) Every truck 80 inches or more in over-all width except a dump truck and except

a truck 80 inches or more in over-all width which is not in excess of 25 feet in over-all

length and manufactured prior to January 1, 1965, shall be equipped with the following

lamps and reflectors in addition to those provided for in paragraph (a) of this section; On the front, two clearance lamps, one at each side, and three identification lamps except that where the cab is not more than 42 inches wide at

the front roof line, a single lamp at the center of the cab shall be deemed to comply

with the requirement for front identification lamps; On the rear, two clearance lamps, one at each side, and three identification lamps; On each side, one side-marker lamp and one reflector at or near the front, and one

side-marker lamp and one reflector at or near the rear. (d) Every trailer or semitrailer shall be equipped on the rear with two tail lamps, two stop lamps, two turn signals , and two reflectors, one of each at each side, and with adequate license plate illumination. (e) Every trailer or semitrailer 80 inches or more in over-all width, except a dump

truck trailer, a dump truck semitrailer , or a converter dolly, shall be equipped with the following lamps and reflectors in

addition to those provided for in paragraph (d) of this section: On the front, two clearance lamps, one at each side; On the rear, two clearance lamps, one at each side, and except with respect to cable reel trailers, three identification lamps; On each side, one side-marker lamp and one reflector at or near the front, and one

side-marker lamp and one reflector at or near the rear; and on any trailer or semi-trailer vehicle 30 feet or more in length, at least one additional side-marker lamp at optional

height and at least one additional reflector, the additional lamp or lamps and reflector or reflectors to be at or near the center or at approximately uniform spacing in the length of

the vehicle. (f) Every pole trailer shall be equipped as follows: On the rear, two tail lamps, one at each side; two stop lamps, one at each side; two turn signals, one at each side; two reflectors, one at each side, placed to indicate extreme width of the pole trailer; three identification lamps mounted on the vertical center line of the pole trailer or in

lieu thereof mounted on the vertical center line of the rear of the cab of the truck

tractor drawing the pole trailer and higher than the load being transported. On each side, one amber side-marker lamp at or near the front of the load; one amber

reflector at or near the front of the load; on the rearmost support for the load,

one combination marker lamp showing amber to the front and red to the rear and side,

mounted to indicate maximum width of the pole trailer; on the rearmost support for

the load, one red reflector. Nothing in this subsection shall apply to a single axle, skeleton frame trailer, not exceeding 2,500 pounds

net weight and not exceeding 80 inches in over-all width which is designed to transport

poles and is owned by a public utility as defined in R.S.48:2-13 except that such vehicles shall be required to have on the rear, two tail lamps, one at each side; stop lamps, one at each side; two turn signals, one at each side; two reflectors, one at each side on each side; and one amber side-marker lamp at or

near the front of the load. (g) Every converter dolly not permanently attached to a semitrailer shall be equipped

on the rear with one stop lamp, one tail lamp, two reflectors, one at each side, and adequate license plate illumination. These lamps need be lighted only when the converter dolly is being towed singly

by another vehicle. A “ converter dolly ” is a vehicle with a fifth wheel lower half or equivalent mechanism, the attachment

of which converts a semitrailer to a trailer. (h) Every motorcycle shall be equipped with at least one and not more than two headlamps, one tail lamp, one stop lamp, at least one reflector on the rear, adequate

license plate illumination and, if a side car or any other extension is attached to

the side thereof, one lamp located on the outside limit of the attachment capable

of displaying white light to the front. (i) Required lamps and reflectors shall be of a type approved by the chief administrator . Turn signals shall be Class A Type 1 lamps except that on passenger cars, and on

commercial vehicles less than 80 inches in over-all width they may be Class B lamps. Reflectors shall be Class A reflex reflectors except that on passenger cars they

may be Class B reflex reflectors. (j) Required headlamps, tail lamps, clearance lamps, identification lamps , and side-marker lamps shall be lighted and adequate license plate illumination displayed

whenever the vehicle other than a converter dolly is upon a highway when lighted lamps

are required except when parked and exhibiting lights as provided for in R.S.39:3-62 or when stopped and displaying emergency warning lights or devices as provided for

in R.S.39:3-64 or R.S.39:3-54 . Lamps on a converter dolly shall be lighted as provided for in paragraph (g) of

this section. Turn signals on the side toward which a vehicle turn is made shall be flashed to

indicate the turning movement. Stop lamps shall be lighted as provided in section 9 of P.L.1964, c. 136 ( C.39:3-61.3 ) . (k) License plate illumination will be deemed to be adequate when either a tail lamp

or a separate lamp is so constructed and placed as to illuminate with a white light

the rear license plate on a vehicle and render it clearly legible from a distance of 50 feet to the

rear. Any lamp or lamps providing illumination shall be lighted whenever the headlamps or other driving lamps are lighted. ( l ) Whenever a law enforcement officer detects a motor vehicle with a lamp not in working

order, the driver may be permitted to park the vehicle temporarily at some safe place

nearby and make the necessary repairs or replacement to restore the lamp to working

order before moving the vehicle, in which event, there is no violation of this Title. (m) Every motorbus manufactured before January 1, 1960, that has been inspected and

approved as to construction and safety devices by the Board of Public Utility Commissioners

shall be deemed in compliance with the requirements of this section.