Nevada § 582.210 - Requirements for weighing vehicle or combination of vehicles; variance

§ 582.210. Requirements for weighing vehicle or combination of vehicles; variance

1. Except as otherwise provided in subsection 2: (a) A public weighmaster shall not weigh a vehicle or combination of vehicles when

part of the vehicle or connected combination is not resting fully, completely and

as one entire unit on the scale. (b) When weighing a combination of vehicles that will not rest fully, completely and

as one complete unit on the scale platform: (1) The combination of vehicles must be disconnected and weighed in single drafts;

and (2) The weights of the single drafts may be combined in order to issue a single certificate

of weights and measures for the combination, provided that the certificate indicates

that the total represents a combination of single draft weighings. 2. A public weighmaster who operates a vehicle scale that was installed before January

1, 2004, may apply to the State Sealer of Measurement Standards for a permanent variance

from the requirements of subsection 1 that would allow the split weighing of certain

vehicles or combinations of vehicles. The request must contain: (a) The name, address and telephone number of the public weighmaster and the reason

for the request. (b) The name of the manufacturer, and the type, location, deck length, serial number

and capacity, of the vehicle scale. (c) The maximum distance between the front and rear outer axles of a vehicle or combination

of vehicles to which the variance would apply. (d) A statement certifying that, during the split weighing of any vehicle or combination

of vehicles, the public weighmaster will verify that: (1) Each axle of the vehicle or combination of vehicles rests on a straight surface

which is level with the deck of the vehicle scale or which, if not level, the amount

by which it is out of level does not exceed 1 / 3 inch per foot of distance between the deck of the vehicle scale and the axle; (2) The brakes of the vehicle or combination of vehicles are not used; and (3) The transmission of the vehicle or combination of vehicles is in neutral.