Montana § 60-3-206 - Apportionment Of Funds To Secondary Highway System -- Definitions

§ 60-3-206. Apportionment Of Funds To Secondary Highway System -- Definitions

Apportionment of funds to secondary highway system -- definitions. (1) Each fiscal year the department shall apportion at least 65% of the federal-aid highway funds allocated for the secondary highway system among the districts for capital construction needs. The remainder of the funds must be used by the department for secondary highway system pavement preservation. The proportion that each district receives is computed on the following basis: (a) 30% in the ratio of land area in each district to the total land area in the state; (b) 35% in the ratio of the rural population in each district to the total rural population in the state; (c) 30% in the ratio of the rural road mileage in each district to the total rural road mileage in the state; and (d) 5% in the ratio of the rural bridge square footage in each district to the total rural bridge square footage in the state. (2) To the extent necessary to permit orderly programming and construction of projects, obligations in a district may exceed the amount apportioned to that district if a majority of the boards of county commissioners of the counties in another district approve the donation of the extra amount. The amount of excess obligations must be deducted from future apportionments to that recipient district and returned to the donor district. (3) As used in this section, the following definitions apply: (a) "Capital construction" means a highway or bridge project undertaken to improve structural strength, increase capacity, or eliminate hazardous design features. A capital construction project may include paved or gravel road reconstruction and rehabilitation. (b) "District" means the transportation commission districts identified in 2-15-2502 . (c) "Pavement preservation" means a project undertaken to extend the useful life of a paved road. (d) "Rural bridge square footage" means the total square footage of all deck areas of structures 20 feet long or longer located on the roadways that are used to calculate rural road mileage as provided in subsection (3)(f). (e) "Rural population" means the total population of all of the counties in a district as reported in the latest decennial federal census less the population in cities over 5,000 persons and their unincorporated fringe urban areas as determined by the department, using the latest decennial federal census. (f) (i) "Rural road mileage" means all road mileage on roads functionally classified and approved by the transportation commission as major collectors or minor arterials, exclusive of road mileage on the primary highway system. (ii) Road mileage within national parks or road mileage that lies within incorporated cities over 5,000 persons and their unincorporated fringe urban areas, whose population is determined by the department, using the latest decennial federal census, is not considered rural road mileage. (iii) Rural road mileage reported by the road inventory of the department must be used in determining rural road mileage. (4) For the purpose of determining secondary highway capital construction priorities within a district, each board of county commissioners in a district has one vote and the department has two votes. An existing paved secondary highway may not be converted to a graveled surface without the concurrence of the board of county commissioners in the county where the road is located.