Alabama § 25-9-215 - Safety Devices and Practices.

Full text of Alabama Code of Alabama § 25-9-215 — Safety Devices and Practices., with citation guidance and answers to common questions.

§ 25-9-215. Safety Devices and Practices.

(a) Locomotives shall be equipped with proper devices for the rerailing of locomotives and cars.

(b) An audible warning device and headlights shall be provided on each locomotive.

(c) Approved trip markers shall be used on the rear of trips pulled or pushed and on the front of trips lowered into slopes. Markers are not required to be used during gathering operations at working faces. Permissible trip lights, efficient reflectors, or closed nonpermissible trip lights are acceptable as trip markers.

(d) Other than the motorman and trip rider, no person shall ride on a locomotive unless authorized by the mine foreman, and no person shall ride on loaded cars or between cars of any trip; except, that the trip rider may ride on the part of the trip adjudged safest by the mine foreman and concurred in by the mine inspector, preferably the first or the last car. When officials or other persons authorized by the mine foreman, trafficman, haulage boss, or dispatcher are transported on loaded trips, an empty car shall be placed between the locomotive and the first loaded car, or when physical conditions of haulage require it as a safety measure, the mine foreman may designate the rear of trips for the empty to be placed.

(e) Motormen and trip riders shall not get on or off the cars, trips, or locomotives in motion; except, that a trip rider may get on or off the rear end of a slowly moving trip to throw a switch or perform other necessary haulage duties.

(f) Slides, skids, or other adequate means shall be used on descending trips on grades where the locomotive or car tugger hoist is not adequate to control the trip.

(g) On any slope or plane where the grade is against loaded trip, a drag or other suitable device, adequate to derail cars or the trip of cars in case they break loose and run back, shall be used.

(h) Uniform haulage signals shall be adopted for each mine or mines operated, and shall be complied with by all haulage crews.

(i) Flying or running switches are forbidden. Mine rules as to block signals and other haulage practices not covered in these laws shall be complied with by all officials, haulage crews, and other workmen.

Source: official Alabama text · Last verified 2026-08-27

Frequently Asked Questions About Alabama § 25-9-215

What does Code of Alabama § 25-9-215 cover?

Section 25-9-215 ("Safety Devices and Practices.") is part of the Code of Alabama, the codified statutory law of Alabama. It sets out the legal rule or procedure described in the text above. Statutes are amended regularly, so always verify against the official source.

How do I cite Alabama § 25-9-215?

A common citation format is "Code of Alabama § 25-9-215" (Alabama). Legal writing may require the code abbreviation, section number, and year or edition. Match the style required by your court, professor, or publisher.

Is this the official text of Alabama law?

No. This page is for research and education and may not include the most recent amendments. For official current law, check the Alabama official source linked on this page or consult a licensed Alabama attorney.

How does Alabama § 25-9-215 apply to my situation?

Statutes are interpreted in context, and application depends on your specific facts. Only a licensed attorney in Alabama can advise on how this section applies to you. Contact your state or local bar association for a referral.

Sources & Verification

Not legal advice. Verify against the official source and consult a licensed attorney in Alabama.